|
Input
Sensitivity: |
Adjusts
input gain ±10 dB |
PPM
Meter: |
PPM
5 section led input meter |
Bypass: |
Individual
electronic bypass |
Intensity: |
Mode
1: Amount of Clean Signal
Mode 2: Amount of Effect Signal
Mode 3: Amount of Positive Feedback
Mode 4: Amount of Negative Feedback |
Speed: |
LFO
Speed 0.1 Hz to 10 Hz |
Width: |
Depth
of Modulation 0 to 100% |
Delay: |
Time
from Approx. 0.65 to 21 mSec. |
Stereo
Input: |
Disables
Mix of Input Signals |
Separate
Input: |
Divides
unit into two separate channels |
Sweep
Sync: |
In
Normal Mode - Synchronizes the Two LFO Delay Modulators In-Phase
In Separate Mode - (Both Channels On) Mixes the LFO Delay
Modulators |
Cross
Off: |
In
Normal Mode - Disables Audio Cross Mixing of the Two Channels
In Separate Mode - Disables the Bypass Link of the Two Channels |
Direct
Mute: |
(On
Rear Panel) mutes direct signal |
Frequency
Response: |
10-100.000
Hz, +0 / -1 dB (Direct)
20-20.000 Hz, +0 / -3dB (Delay) |
Dynamic
Range: |
>100
dB |
THD: |
<
0.001% 1 KHz, 0 dBu (Direct)
< 0.03% 1 KHz, 0 dBu (Delay) |
Gain: |
±10
dB Inputs, Unity outputs |
Channel
Separation: |
>
70 dB |
Maximum
Input Level: |
+12
dBm (Phone), +22 (XLR) |
Maximum
Output Level: |
+16
dBm (Phone), +22 (XLR) |
Input
Impedance: |
1MOhm
(Phone), 20 K Ohm (XLR) |
Output
Impedance: |
100
Ohm (Phone), 50 Ohm (XLR) |
Delay
Type: |
Analog
Bucket Brigades, differentially coupled Selectable 110/220V |
Power
Requirements: |
50-60Hz,
18W |
Weight: |
3.5
Kgs. (8Lbs.) |
Dimensions: |
1
3/4 x 19 x 7.3 inches (44 x 482 x 185mm) |
Finish: |
Black
anodized aluminium faceplate
Black painted steel chassis |